Follow your nose!
We recently had this green Bugeye brought into our shop for service, and on a test drive it exhibited a rattle coming from the front of the car. This is not uncommon among Bugeyes that come through our doors; 60-plus year old British cars sometimes make noises like that, and our job is to investigate where they come from and see if we can do anything to mitigate them. In this instance, upon lifting the bonnet we found a smoking gun that led us to the culprit.
When we opened the bonnet, we saw a rub mark on the aluminum radiator (circled in the below photo). There was a corresponding rub mark on the underside of the bonnet, in between the headlight buckets (circled in the above photo). Our aluminum radiators are designed to fit in exactly the correct location as the factory radiators; they aren’t any taller or wider than a stock brass radiator. So why did the bonnet and radiator make contact on this particular car?
Well, there are a couple of reasons this could be. The most common seems to be that almost every Bugeye that comes in here has been in some kind of fender-bender, accident, or has otherwise been the victim of some kind of damaging event that bends parts of the front end, such as the front frame horns, where the radiator mounts. These are sometimes bent upwards, creating a scenario where the radiator could realistically hit the nose. However, in this instance, the answer was much simpler.
There are six main components to the latching mechanism on a Bugeye’s bonnet. Potentially the most important ones are the bonnet locating pegs. These pegs are fitted to the underside of the bonnet and are designed to fit into two corresponding holes on each frame horn, which guide the nose into its moorings and help center it on the car. For some reason, on this Bugeye, these pegs were missing entirely! Not only would this create an issue with centering the nose, but it also made the nose sit about an inch lower than it would with the proper pieces in place, creating the rubbing issue we saw on this car.
The moral of this story is: check your clearances! When installing a radiator on your Bugeye, it’s worth taking the time to lay down a small piece of masking tape at the highest point on the tank, closing the bonnet fully, and then opening the bonnet again. If the tape has a mark on it or looks like it has been pinched between the bonnet and the radiator, then your part will rub and adjustments will need to be made, either to the height of the radiator or the height of the bonnet. And make sure your bonnet pegs are intact!
Should you be missing your bonnet pegs, or any other bonnet fastening part, check out our parts catalog or click on the photos below to get the parts you need today!
